Design a Wireless Battery Fuel Gauge with Nordic + Seeed!
Jinger Zeng
jingerzengAttention Attendees
Prior to entering the workshop, attendees will need to complete a download and installation of the SDK on their laptop. Please see step-by-step instructions.
Please complete the intro exercise and install the SDK (not just the VS Code extension) so that we can focus our in-person time exploring our topic!
Laptops required
An upgrade from last year’s workshop on brand new hardware with Seeed Studio!
Last year, all we did was control some regulator outputs and measure them with an ADC… Let’s go a bit further and truly use the PMIC this year!
In this workshop, we will incorporate a proprietary Fuel Gauge algorithm along with creating a Bluetooth device that can enter ultra low power ship modes, wake up, have bidirectional communication with our mobile device, as well as incorporate the shipmode in software so it can enter an ultra low power mode again!
Very close to a PoC or hardware you can incorporate into your next project, all on one board.
Being on a small seeed board, this gives a great prototyping platform to jump off of. Buy any stemma sensor and incorporate it into the design. Perhaps a screen? Accelerometer? Turn it into a wearable? Tons of possibilities!
Made possible with generous support from these sponsors:
