NUT2NT+
by Amungo Navigation
Four-channel, all-frequency, GNSS RF-to-bits receiver for precision, satellite-based positioning
Counting Down to Launch
Hello to Everyone!
We still plan to start in September. We are vetting local Estonian partners for hardware, especially metal parts manufacturing http://protolab.io/en/ and coating. The first prototype of the NUT4NT+ “good shielded” aluminum enclosure is manufactured and is going to coating. New board fits good. Look at the photo below.
We have also assembled a new board with efficient power supply. After a correction of some bugs the samples stream runs. We are starting to test RF part of the board.
More to come soon.
Credits
Igor Tcarik
Strategic management, design of antennas
Simeon Voropaev
Hardware design, manufacturing and testing
Sergey Speranskiy
PCB design
Ivan Makushkin
Software development, embedded and signal processing
Daria Ianovskaia
RF circuits design, RA antennas LNA and NUT2NT+ board's RF circuits
Dmitriy Bitsulya
Software engineering, C/C++ Developer, NUT2NT+ GNSS-SDR support
Ekaterina Kolomnikova
Hardware assembling
Nadezhda Bybko
Supply and fulfillment management
Vladimir Vikulin
FPGA Design and Verification Engineer, FAE
Artem Krivosheev
FPGA code design
Andrey Khazov
Metal parts design
