Project update 4 of 29
The new website can be viewed here: https://roboticsmasters.co and has been revised to give it a new look and feel.
The third iteration of the board is nearly finalised. We have slightly modified the layout to make the best use of the small space in the HAT format. It also will allow for all the ports to be accessible while stacking another HAT on top (such as Sense HAT, Motor Controller HAT, etc).
We have added the option of selecting which I2C bus people want to use for different sensors though solder pads. This means you could have the data-intensive IMU on it’s on I2C bus to remove any bandwidth issues.
We are also increasing the amount of Flash storage to 8 MB with this revision of the Robo HAT MM1. This will allow for more CircuitPython libraries to be installed, or to capture more data that you want to cache away!
Stay tuned for an alert from us when the Robo HAT MM1 campaign is live! Subscribers are the first to be notified when the campaign officially launches. You can also check out our other Updates (find them at the bottom of our pre-launch page) to learn more about Robo HAT’s development so far.
Robo HAT MM1 is part of Microchip Get Launched