We have good news to share! We received all required screws, nuts and washers for ANAVI Macro Pad 2. Each kit will include a M2.5 x 8 mm screw and a couple of M2.5 x 12 mm screws, 8 nuts and 3 washers. All of these fasteners are required for the assembly of the printed circuit board to the acrylic enclosure.
In the meantime, the Crowd Supply team has arranged all the paperwork for ANAVI Macro Pad 2 shipment. We have already flashed the firmware and tested the majority of the boards. The plan is to package all units and ship them to Crowd Supply’s warehouse in 2-3 weeks. We will keep you updated. Thank you again for supporting ANAVI Macro Pad 2!
The open source smart solder smoke absorber
ANAVI Play pHAT is a super simple, low cost open source hardware add-on board for Raspberry Pi with buttons for retro gaming and slots for up to 3 I2C sensor modules.
Make your lights open source and connect your LED strip to the WiFi network with ANAVI Light Controller!
An ESP8266-powered, open source, Wi-Fi dev board to control two 5 V or two 12 V LED strips
Open source, programmable, eight-key keypad with backlighting, underlighting, and OLED screen
An ESP8266-powered, open source, Wi-Fi dev board with temperature and humidity sensors