It has been a week since the start of the crowdfunding campaign and we have to say thank you for your support! The campaign readily hit its modest target so now we are heading for stretch goals:
In the meantime, take a look at the video tutorial for getting started with ANAVI Light Controller. Although our open source development board doesn’t have a display, it’s still very easy to configure. Using our open source software, you’ll be able to connect your ANAVI Light Controller to your WiFi network in no time!
You can get started in just three easy steps:
As you can see in this demo video, the whole setup takes less than a minute!
Fully Open iCE40 FPGA BeagleBone Cape
Make your Raspberry Pi bright and shiny with an RGB LED strip and ANAVI Light pHAT!
ANAVI Play pHAT is a super simple, low cost open source hardware add-on board for Raspberry Pi with buttons for retro gaming and slots for up to 3 I2C sensor modules.