In this update and few that will follow soon, I’d like to present to you the most important features we added to the recently released firmware M3 (milestone three).
First I’d like to thank to all of you who decided to pledge your support shortly after the campaign started. One of the backers suggested I should mention my nickname prasimix so people could more easily recognize me. :)
In the video below, I introduce "tracking mode," in which you can set the output values, states, and protections on both channels by programming just one of them. This speeds up programming and reduces the chance of error in cases where symmetrical output is needed. For example when 12 V is set on the channel 1, the same voltage will be also be set on channel 2, or when channel 2 output is disabled that will automatically disable channel 1 output, too.
To see more videos, check out our YouTube channel.
Senior Software Developer
A small, portable, USB-connected electronics lab-on-a-board that includes an oscilloscope, waveform generator, power supply, logic analyzer, and multimeter.
A software-enabled network-in-a-box based on LimeSDR
Fully Open ICE40 FPGA BeagleBone Cape