BLYST Nano

by I-SYST inc.

The finger-tip sized ARM Cortex-M4F module with BT 5, BT Mesh, and 30 I/O

View all updates Feb 04, 2019

Sensor Board Delay

We’d like to appolozise for the delay in the production of the BLYST Nano sensor board. Initially, the design was based on the TDK MPU-9250, but by the time Crowd Supply campaign started that chip was announced end of life. Therefore we had to replace it with the new ICM-20948. Unfortunately, it wasn’t compatible. The new chip requires lower operating voltage, which forces us to add a step down converter to 1.8 V instead of the original 3 V design. By doing so, the LED and other components no longer worked. We had to redesign the whole thing. Not only did the hardware change, the driver also has to be re-writen. Hence, the delay plus the Lunar New year holidays causing further delays. We are expecting end of February for the production to finish the Sensor board. However this delay will only affect orders of the sensor board and the discovery kit. All other orders that were placed before Jan 14 has been fulfilled. Orders placed after that date will be fulfilled at the same time as the discovery kit. Thank you very much for your understanding.

In the mean time, please find updated links bellow for the documentation & development resources for the BLYST Nano:


$8,397 raised

of $1,000 goal

839% Funded! Order Below

Product Choices

$32

BLYST Nano x 2

Two BLYST Nano modules.


$80

BLYST Nano x 5

Five BLYST Nano modules.


$168

BLYST Nano Exploration Kit

Two BLYST Nano modules, one DIP32 Breakout Board (assembled with BLYST Module), one Sensor Board (assembled with BLYST Module), and an IDAP-Link CMSIS-DAP Debug JTAG. This is the perfect starter kit.


$30

BLYST Nano Breakout

One fully assembled DIP32 Breakout Board with BLYST Nano module.


$65

BLYST Nano Sensor

One fully assembled Sensor Board with BLYST Nano module.


$65

IDAP-Link CMSIS-DAP Debug JTAG

This a CMSIS-DAP Debug JTAG board for programming and debugging any ARM Cortex-M series supported the the IDE. Compatible with most IDE such as Keil, CrossWorks, Eclipse (requires OpenOCD), Arduino (require OpenOCD), etc ... It can used for production parallel programming of any Nordic nRF5 series SoC.

Credits

I-SYST inc.


Hoan Hoang

Subscribe to the Crowd Supply newsletter, highlighting the latest creators and projects: